GBC StreamPunch Ultra Service Manual page 201

10. To replace the upper bracket, remove the cable clamps, cable,
Alignment sensors, washers, nuts from the old bracket and transfer
them to the new bracket.
GBC StreamPunch Ultra/Ultra MP
Installation Procedure
1. Replace the bracket so the lower bracket (Alignment Sensor bottom
guide) will overlap the top bracket when assembled.
2. Insert both Brackets and position them.
3. Install and tighten the M3 Nuts (2) that hold the Brackets.
4. Connect the Alignment Sensor Connector, and place the Cable in the
Cable Clamps.
5. Install the Steering Idler Roller Cover.
6. Connect the Skew Sensor Connector and place the Cable in the
Cable Clamps.
7. Do ARP 3.1 to install the Punch Module.
8. Do ARP 1.6 to install the Rear Cover.
9. Connect the Power Cord.
02-03-2017
4-121
Adjustments/Repairs