Gp 6.14.1 Idler Roller Cleaning - GBC StreamPunch Ultra Service Manual

GP 6.14.1 Idler Roller Cleaning

Use this procedure to clean the Idler Rollers in these assemblies:
• Entrance Idler Panel.
• Acceleration Roller Idler Assy.
• Exit Idler Panel.
• Bypass Idler Assembly
Maintenance Schedule
Inspect and clean every 1000K cycles.
Procedure
1. Do ARP 2.4 Idler Roller Replacement to remove the Idler Roller.
Idler Roller Shaft Idler Roller
Retaining Spring
2. Clean the Idler Rollers with a soft cloth and alcohol.
3. Inspect rollers for wear patterns or groves. The roller surface should
be smooth.
4. Ensure the rollers turn freely on the shaft and that the idler roller shaft
"floats" freely in the bushing forks.
5. Do ARP 2.4 Idler Roller Replacement to install the Idler Roller.
GBC StreamPunch Ultra/Ultra MP
Bearing Housing
11-05-2018
6-53
General Procedures and Information