4. Power Supply
ARP 4.1 24V Power Supply Replacement
PARTS LIST ON PL 2.5
Use this procedure to remove and install the 24V Power Supply
Assembly.
Removal Procedure
WARNING
Do not perform Repair activities with the power on or electrical
power supplied to the machine. Some machine components contain
dangerous electrical voltages that can result in electrical shock and
possible serious injury.
1. Disconnect the Power Cord.
2. Do ARP 1.6 to remove the Rear Cover.
3. Dsiconnect Connectors J1 and J3 from the Main Control Board.
4. Remove the M4 Screw (1) and remove the Ground Cable from the
Power Supply.
5. Remove the M4 Screws (4) from the side of the Base Frame.
GBC StreamPunch Ultra/Ultra MP
6. Remove the power supply and the cables through the opening on top.
Connector
Screw
02-03-2017
4-125
Assist the connectors to get through the grommet while removing.
Cable clamps should also be released to free up the cables.
Screws (4)
Grommet
Adjustments/Repairs