GBC StreamPunch Ultra Service Manual page 46

RTP 2.7 Multiple Sheets Jammed - Die Pins Partially
Through the Sheets
Use this RTP if there are multiple sheets jammed with the die pins
partially through the sheets.
1. Crank the punch shaft in the clock-wise CW direction (when viewed
from the front of the machine) using the flats in the front of the
machine.
Flats are also present in the back side of the shaft which can be
accessed by removing the rear cover. (rotate counter clock wise CCW
when viewed from the back side)
2. Remove the jammed sheets.
3. If it is too difficult to crank the punch shaft:
• Remove rear cover.
• Disconnect the clutch wires at the Clutch Solenoid
• Remove two screws that hold the Punch Clutch Bracket
GBC StreamPunch Ultra/Ultra MP
• Rotate the Clutch along with the shaft in the opposite direction
(clockwise CW direction when viewed from the back) until the
pins exit the sheet.
• Remove the jammed sheets.
• Return the Clutch Bracket and the Clutch to their positions and
install the Screws.
• Connect the clutch wires at the Clutch Solenoid In the Function
mode of the LCD screen, run Cycle Punch to verify the punch
cam returns to home position. If it does not, do ADJ 1.5 to
perform Punch Clutch Indexing.
11-05-2018
2-29
RTPS