GBC StreamPunch Ultra Service Manual page 283

GP 6.1.2 ALIGNMENT SETTING Procedure
Do the following to change the Alignment (move the inboard/outboard
position of the punch holes). This setting applies to all paper sizes
1. From the top level screen, press either the up arrow button or the
down arrow button.
READY
SINGLE PUNCH
This displays the SETTINGS - INFORMATION screen
SETTINGS
INFORMATION
2. Press the ENTER button when the return symbol is next to the word
SETTINGS. To display the display the BACKGAGE/ ALIGNMENT
screen.
BACKGAGE
ALIGNMENT
3. Press the down arrow button once so the return symbol is next to the
word ALIGNMENT.
BACKGAGE
ALIGNMENT
4. Press the ENTER button when the return symbol is next to the word
Alignment to display the ALIGNMENT OFFSET screen.
ALIGNMENT OFFSET
0.0 mm
GBC StreamPunch Ultra/Ultra MP
5. Press the up arrow button or the down arrow button to change the
offset by+ 0.1mm.
ALIGNMENT OFFSET
0.0 mm
• A + offset moves the position of the punch holes toward the rear
of the machine (shallower).
• A - offset moves the position of the punch holes toward the front
of the machine (deeper)..
• The maximum alignment change is + 2.0 mm.
11-05-2018
6-9
General Procedures and Information