GBC StreamPunch Ultra Service Manual page 120

8. Remove the Handle assembly by removing (2) screws.
9. Remove the Idler Panel Mount Bracket from the rear frame.
10. Remove the Upper Bypass Assembly.
Installation Procedure
1. Transfer the Idler rollers, springs, sensors, Bypass Open sensor flag,
Magnetic latches to the new part.
2. Place the Upper Bypass Assembly.in position.
3. Install the the Handle Assembly.
4. Install the (2) Idler panel magnetic latches.
5. Install the Idler Panel Mount Brackets (2) on the rear frame.
6. Place the Shaft in position and install the (2) E-clips.
7. Connect the Sensors from the Upper Bypass Panel and place the
sensor cables in the cable clamps.
8. Install the gound strap.
9. Do ARP 1.6 Rear Cover Replacement to install the Rear Cover.
10. Do GP 6.4 to dock the Punch to the upstream and downstream
equipment.
11. Do ADJ 1.7Idler Panel Magnetic Latches adjustment.
12. Connect the Power Cord.
Adjustments/Repairs
GBC StreamPunch Ultra/Ultra MP
02-03-2017
4-40