GBC StreamPunch Ultra Service Manual page 116

10. Remove (5) screws from the rear frame that mount the Exit drive
panel.
11. Remove the Drive Exit Panel.
Adjustments/Repairs
Installation Procedure
1. Place the Drive Exit Panel in position.
2. Install the new Drive exit panel, by installing the (5) screws in the front
frame and (5) screws in the rear frame.
3. Do ADJ 1.8 Drive Panel Position Adjustment
4. Place the Timing Belt Tensioner Assembly of Motor M6 in position
and tighten the (2) nuts.
5. Do ARP 2.27 to install Motor M7.
6. Place the Bracket in position in Area 5 of the machine, and tighten the
(3) M4 nuts.
7. Do ARP 2.7 to install the Exit Idler Panel.
8. Do ARP 2.6 to install the Lower Exit Panel.
9. Do ADJ 1.7 Idler Panel Magnetic Latches Adjustment.
10. Do ARP 1.18Error! Reference source not found. Downstream
Docking plate removal to install the downstream docking plate
11. Do GP 6.4 to dock the Punch to the upstream and downstream
equipment.
12. Connect the Power Cord.
GBC StreamPunch Ultra/Ultra MP
02-03-2017
4-36