GBC StreamPunch Ultra Service Manual page 114

14. To replace the Exit Idler Panel Weldment do the following procedures
to remove and install these components.
•
ARP 2.15 Idler Roller Replacement
•
ARP 2.28.2 Top, Middle, & Bottom Exit Sensor (S22, S23, S24)
Replacement
•
ARP 2.30.4 Exit Idler Solenoid Replacement
•
ARP 2.6 Panel Close Magnet Replacement
Adjustments/Repairs
Installation Procedure
1. Place the Exit Idler Panel in position.
2. Insert the Shaft through the holes (2) at the left side of the Exit Idler
Panel.
3. Install the E-Rings (2) at the top and bottom of the Shaft.
4. Connect the Connectors for Solenoids SOL5, SOL6 & SOL7 to the
header.
5. Connect the Connectors for Sensors S22, S23, & S24.
6. Place the sensor cables into the Cable Clamps, and close the Clamps
7. Install the ground strap
8. Do ARP 1.18 to install the Downstream docking plate.
9. Do GP 6.4 Dock the Punch to connect the Punch to the downstream
devices.
10. Close the Front Door.
11. Connect the Power Cord.
GBC StreamPunch Ultra/Ultra MP
02-03-2017
4-34