Solenoid Checks; Rtp 4.1; Check Solenoid Sol 1; Check Solenoid Sol 2 - GBC StreamPunch Ultra Service Manual

4 SOLENOID CHECKS

RTP 4.1

Check Solenoid SOL 1

Solenoid SOL1 is the diverter solenoid- mechanical adjustment is covered
in detail in ADJ 1.2 Diverter Solenoid Adjustment.
1. Open the front the door and insert an Interlock Cheater into the
Punch Door interlock Switch SW4 (PL 2.8).
WARNING
Moving Parts, keep hands clear of nips and the belts when
the Interlock Cheater is inserted.
2. Do GP 6.2.6 SOLENOIDS Procedure to activate and deactivate
Solenoid SOL1.
The diverter gate should rise and fall when SOL1 is cycled.
Diverter gate rises and falls when SOL1 is cycled
Yes- Return to the RTP that directed you here
No- Go to Step 3 and choose the appropriate condition
3. If SOL1 does not function, do the below steps:
• Do ARP 1.6 to remove the Rear Cover.
• Check the cable from the solenoid to the in-line header. This
cable is part of the solenoid body.
• Check the cable 7715466 that connects the in-line header to the
Main Control Board.
• Replace the SOL1 (ARP 2.28.1) or 7715466, as needed.
If SOL1 functions, do the below steps:
• Go to ADJ 1.2 Diverter Solenoid Adjustment and perform
adjustment if necessary.
This clears the fault
Yes- Return to normal operation
4. Do GP 6.2.12 FIRMWARE UPGRADE Procedure to Re-flash the
firmware for the StreamPunch Ultra/Ultra MP.
This clears the fault
Yes- Return to normal operation; No- Go to Step 5
GBC StreamPunch Ultra/Ultra MP
No- Go to Step 4
5. Do ARP 2.28.1 Diverter Solenoid Replacement.
This clears the fault
Yes- Return to normal operation; No- Go to Step 6
6. Do ARP 5.1. Main Control Board Replacement.
This clears the fault
Yes- Return to normal operation; No- Escalate to second level
RTP 4.2

Check Solenoid SOL 2

Solenoid SOL 2 is the Punch Clutch, see:
• RTP 2.4 Jam Type D.
• RTP 2.7 Multiple Sheets Jammed - Die Pins Partially Through the
Sheets.
11-05-2018
2-43
RTPS