Arp 2.28 Paper Path Sensor Replacement; Arp 2.28.1 Entrance Sensor (S1,) Exit Sensor (S25), And Bypass; Middle Sensor (S26) Replacement - GBC StreamPunch Ultra Service Manual

ARP 2.28 Paper Path Sensor Replacement
PARTS LIST ON PL PL 3.1, 3.2, PL 3.3, PL 3.4, PL 3.5, 4.2
Use the following procedures to remove and install the paper path
sensors.
WARNING
Do not perform Repair activities with the power on or electrical
power supplied to the machine. Some machine components contain
dangerous electrical voltages that can result in electrical shock and
possible serious injury.
Sensor # ARP #
S1 ARP 2.25.1
S2 ARP 2.25.2
S3 ARP 2.25.2
S4 ARP 2.25.2
S5 ARP 2.25.3
S6 ARP 2.25.6
S7 ARP 2.25.6
S8 ARP 2.25.6
S9 ARP 2.25.6
S10 ARP 2.25.6
S11 ARP 2.25.7
S12 ARP 2.25.7
S13 ARP 2.25.7
S14 ARP 2.25.7
GBC StreamPunch Ultra/Ultra MP
Sensor # ARP #
S15 ARP 2.25.7
S16 ARP 2.25.8
S17 ARP 2.25.8
S18 ARP 2.25.5
S19 ARP 2.25.5
S20 ARP 2.25.5
S21 ARP 2.25.5
S22 ARP 2.25.2
S23 ARP 2.25.2
S24 ARP 2.25.2
S25 ARP 2.25.1
S26 ARP 2.25.1
S28 ARP 2.25.4

ARP 2.28.1 Entrance Sensor (S1,) Exit Sensor (S25), and Bypass

Middle Sensor (S26) Replacement

Use this procedure to remove and install the Sensor and Bracket
Assembly for the Entrance Sensor, S1 and Exit Sensor, S25.
1. Disconnect the Power Cord.
2. Open the Front Door.
3. Disconnect the Sensor Connector at the Sensor.
4. Remove the Barrell screw that secures the Sensor to the sheet metal
part.
5. Remove the old Sensor.
6. Place the new Sensor in position, then install the Barrell Screw.
7. Close the Front Door.
8. Connect the Power Cord.
02-03-2017
4-65
S25
S26
S1
Adjustments/Repairs