GBC StreamPunch Ultra Service Manual page 103

9. Remove the E-Ring from the bottom of the Idler Panel Shaft.
E-Ring
(Cont.)
10. Remove the E-Ring from the top of the Idler Panel Shaft.
11. Open the Entrance Idler Panel from the front side.
GBC StreamPunch Ultra/Ultra MP
E-Ring
02-03-2017
12. Carefully remove the Shaft.
(Cont.)
13. Grasp and remove the Entrance Idler Panel.
Entrance Idler Panel
14. Do the following to transfer the Sensors, Solenoid Modules, Idler
Rollers, Springs, and Panel Magents to the new weldment.
•
ARP 2.4 Idler roller Assembly Replacement
•
ARP 2.28.3 Sensor (S2, S3, S4) Replacement
•
ARP 2.30.2 Disengaging Roller Solenoid Replacement
4-23
Shaft
Adjustments/Repairs