Scuff Marks On Paper; Wrinkle In The Sheet; Clear Cover Media Hole Position - GBC StreamPunch Ultra Service Manual

3.11 Scuff Marks on Paper

1. Clean all drive and idler rollers, do
• GP 6.14.1 Idler Roller Cleaning
• GP 6.14.2 Steering Idler Roller and Springs Inspection and
Cleaning
• GP 6.15 Drive roller and Steering drive roller Inspection
and Cleaning
This clears the fault
Yes- Return to normal operation; No- Go to Step 2
2. Do RTP 4.3 to inspect Solenoids SOL 3, SOL 4, SOL 5, SOL 6,
SOL 7, and SOL 8.
This clears the fault
Yes- Return to normal operation; No- Go to Step 3
3. Do RTP 3.1 to inspect Sensors S3, S4, S5, S22, S23, and S24
This clears the fault
Yes- Return to normal operation;

3.12 Wrinkle in the sheet

1. If the wrinkling is at the trail edge of the sheet, Do RTP 3.1 to
check Sensor S24.
This clears the fault
Yes- Return to normal operation; No- Go to Step 2
2. Do RTP 4.3 to inspect Solenoids SOL 6, SOL 7, and SOL 8.
This clears the fault
Yes- Return to normal operation;
Punch Quality
No- Escalate to higher level
No- Escalate to higher level

3.13 Clear Cover media hole position

1. If the hole position (Backgage and Alignment) of Clear media
differs from the hole position of plain media, do GP 6.1.3
CLEAR COVER Procedure
This clears the fault
Yes- Return to normal operation; No- Go to Step 2
2. Check the function of Sensor S1b.
Sensor S1b functions properly
Yes- Escalate to next level; No- Go to Step 3
3. Ensure the sensor S1b is connected properly on the receiver
side and emitter side.
Sensor S1b is connected properly
Yes- Escalate to next level; No- Go to Step 4
4. Replace defective S1b receiver or emitter if needed.
New S1b sensors correct the issue.
Yes- Continue normal operation; No- Escalate to next level.
11-05-2018
3-12
GBC StreamPunch Ultra/Ultra MP