Arp 3.17 Steering Drive Panel Weldment Replacement - GBC StreamPunch Ultra Service Manual

ARP 3.17 Steering Drive Panel Weldment Replacement
PARTS LIST ON PL 4.5
Use this procedure to remove and install the Steering Drive Panel
Weldment.
WARNING
Do not perform Repair activities with the power on or electrical
power supplied to the machine. Some machine components contain
dangerous electrical voltages that can result in electrical shock and
possible serious injury.
Removal Procedure
1. Disconnect the Power Cord.
2. Do ARP 1.6 to remove the Rear Cover.
3. Do ARP 3.15 (through step 6) to remove the Steering Idler Panel Sub
Assembly.
4. Remove the Spacers (2).
Spacer
Adjustments/Repairs
5. Remove the Nuts (4) holding the Steering Drive Panel Weldment.
6. Replace with new part
Installation Procedure
1. Place the Steering Drive Panel Weldment in place.
2. Tighten the Nuts (4) that hold the Steering Drive Panel Weldment.
3. Install the Spacers (2).
4. Do ARP 3.15 to install the Steering Idler Panel Sub Assembly.
5. Do ARP 1.6 to install the Rear Cover.
6. Connect the Power Cord.
Spacer
02-03-2017
4-112
GBC StreamPunch Ultra/Ultra MP