Arp 5.3 Dieset Recognition Reader Board Replacement - GBC StreamPunch Ultra Service Manual

ARP 5.3 Dieset Recognition Reader Board Replacement

PARTS LIST ON PL 4.9
Use this procedure to remove and install the Dieset Recognition Reader
Board
WARNING
Do not perform Repair activities with the power on or electrical
power supplied to the machine. Some machine components contain
dangerous electrical voltages that can result in electrical shock and
possible serious injury.
1. Disconnect the Power Cord.
2. Do ARP 1.6 to remove the Rear Cover.
3. Disconnect the Connector at the Dieset Recognition Reader Board.
4. Remove the Screws (2) and the Dieset Recognition Reader Board.
5. Place the Dieset Recognition Reader Board in position and tighten
the Screws (2).
6. Connect the Connector to the Dieset Recognition Reader Board.
7. Do ADJ 1.6 Dieset Recognition Board Adjustment to set the Dieset
Recognition Reader Board.
8. Do ARP 1.6 to install the Rear Cover.
9. Connect the Power Cord.
GBC StreamPunch Ultra/Ultra MP
02-03-2017
4-131
Adjustments/Repairs