Rtp 3.3 Checking Sensor S28 Align Home Sensor - GBC StreamPunch Ultra Service Manual

RTP 3.3 Checking Sensor S28 Align Home Sensor
Location
To Access Sensor S28:
• Open the Front Door.
• To uncover this sensor, slide the Alignment carriage towards the
front of the machine.
• To cover this sensor, slide the Alignment carriage towards the
rear of the machine.
GBC StreamPunch Ultra/Ultra MP
S28
Procedure
1. Do GP 6.2.5 SENSORS Procedure. Check to make sure the sensor
shows "1" on the LCD when the Alignment carriage flag blocks the
sensor and "0" when the Alignment carriage flag unblocks the sensor.
LCD shows "0" when unblocked and "1" when blocked
Yes- Return to the RTP that directed you here.
No- Go to Step 2
2. Make sure the sensor wire is connected securely at the header in the
punch module frame and the main control board
See the Sensor Cables table on page 2-35 for cable numbers.
See Section 7 Wiring for the location of the Connector.
Connection is secure at the punch frame and Control board.
Yes- Go to Step 3;
No- Make the connection and resume normal operation
3. With the front door open, check if the sensor wire is connected
securely at the sensor and the punch module frame on the inside.
Connection is secure at both ends
Yes- Go to Step 4;
No- Make the connection and resume normal operation
4. Replace the Align Home Sensor ARP 2.25.4
This clears the fault
Yes- Resume normal operation;
5. Visually inspect the Sensor cable 7715519 from Sensor to Punch
frame header; 7715457 Punch frame header to Control board. If the
cable is damaged, replace the cable. To closely inspect the sensor
cable from sensor to header, it is recommended to undock the punch.
Cable appears to be damaged
Yes- go to Step 7 or 8;
6. Do GP 6.2.12 FIRMWARE UPGRADE Procedure to Re-flash the
firmware for the StreamPunch Ultra/Ultra MP.
This clears the fault
Yes- Resume normal operation;
11-05-2018
2-41
No- Go to Step 5
No- Go to Step 6
No- Go to Step 7
RTPS