GBC StreamPunch Ultra Service Manual page 190

9. Remove the Roller Assembly.
Steering Idler Roller Assembly
Adjustments/Repairs
Installation Procedure
1. Place the new Roller Assembly in position.
2. Gently move the Springs (2) on to the ends of the Roller.
Spring
3. Ensure the Springs (2) are over the white Roller Bushings (2).
4. Place the Roller Cover in position.
5. Install and tighten the M4 Nuts (2).
6. Place the Skew Sensor Board Cable in the Cable Clamp and close
the Cable Clamp.
7. Connect the Skew Sensor Board Connector.
8. Do ARP 3.1 to install the Punch Module.
9. Do ARP 1.6 to install the Rear Cover.
10. Connect the Power Cord.
GBC StreamPunch Ultra/Ultra MP
02-03-2017
4-110