GBC StreamPunch Ultra Service Manual page 162

17. Do the following to remove the Punch Module Mount Bracket (Lock
Plates).
•
Use a Phillips Head Screwdriver to remove the Screw from the
right Punch Module Mount Bracket.
•
Remove the right Punch Module Mount Bracket.
•
Use a Phillips Head Screwdriver to remove the Screw from the
right Punch Module Mount Bracket.
•
Remove the right Punch Module Mount Bracket.
Adjustments/Repairs
18. Do the following to remove the Punch Module
•
Grasp the handle and slowly pull the punch module out for about
100mm.
•
Reach in and grasp the rear handle and continue to slide the
punch. Lift the punch off the rail- DO NOT let it drop on the
control board.
GBC StreamPunch Ultra/Ultra MP
02-03-2017
4-82