Gp 6.1.11 Firmware Procedure - GBC StreamPunch Ultra Service Manual

GP 6.1.11 FIRMWARE Procedure

The Firmware feature identifies the level of the firmware installed to the
StreamPunch Ultra/Ultra MP.
1. From the top level screen,
READY
SINGLE PUNCH
1. Press either the up arrow button or the down arrow button to display
the SETTINGS/INFORMATION screen.
SETTINGS
INFORMATION
2. Press the down arrow button to move the return symbol down until it
is next to the word INFORMATION,
SETTINGS
INFORMATION
3. Press the ENTER button to display the DIE TYPE – DIE CYCLES
screen.
DIE TYPE
DIE CYCLES
4. Press the down arrow button so the return symbol is next to the word
FIRMWARE.
PUNCH CYCLES
FIRMWARE
GBC StreamPunch Ultra/Ultra MP
5. Press the ENTER button when the return symbol is next to the word
Firmware to display the FIRMWARE screen.
FIRMWARE
0B.48
6. Press the ENTER button to display the PUNCH CYCLES –
FIRMWARE screen.
PUNCH CYCLES
FIRMWARE
7. Press the up or down arrow button to display the EXIT option.
INFORMATION
EXIT
8. Press the ENTER button to return to the top level screen
READY
SINGLE PUNCH
11-05-2018
6-19
B1.20
General Procedures and Information