Arp 5.2 Comm Board Replacement - GBC StreamPunch Ultra Service Manual

ARP 5.2 Comm Board Replacement

PARTS LIST ON PL 6.1
Use this procedure to remove and install the Comm Board.
WARNING
Do not perform Repair activities with the power on or electrical
power supplied to the machine. Some machine components contain
dangerous electrical voltages that can result in electrical shock and
possible serious injury.
Removal Procedure
1. Disconnect the Power Cord.
2. Do ARP 1.6 to remove the Rear Cover.
3. Disconnect the Connectors (3).
•
Connector J14
•
Connector J15
•
Connector J16
4. Using pliers release (2) standoffs and remove the Comm board by
pulling down on the plug-in connector.
Adjustments/Repairs
Installation Procedure
1. Place the new Comm Board in position by inserting the plug-in
connector to the main board and pressing on (4) standoffs until it
snaps in place.
2. Connect the Connectors (3).
Cable/Wire #
7715498 J14 COMM Board
7715494 J15 COMM Board
7715726 J16 COMM Board
3. Do ARP 1.6 to install the Rear Cover.
4. Connect the Power Cord.
GBC StreamPunch Ultra/Ultra MP
02-03-2017
4-130
Connector #