Arp 1.6 Rear Cover Replacement - GBC StreamPunch Ultra Service Manual

ARP 1.6 Rear Cover Replacement

PARTS LIST ON PL 1.2
Use this procedure to remove and install the Rear Cover Assembly
Removal Procedure
WARNING
Do not perform Repair activities with the power on or electrical
power supplied to the machine. Some machine components contain
dangerous electrical voltages that can result in electrical shock and
possible serious injury.
1. Disconnect the Power Cord.
2. Disconnect all the cables from the rear side of the machine.
3. Remove the 2 MK 737s from the back of the machine. Each is held
with 4 screws.
4. Hold the Rear Cover in place so it doesn't fall as you remove the
Screws (7) from the Rear Cover, 5 on the back and 2 on the upstream
side.
5. Grasp the Rear Cover by the handle and remove the Rear Cover.
Installation Procedure
1. Place the Rear Cover in position.
2. Tighten the Screws (7) on the Rear Cover.
3. Replace the MK 737s
4. Connect the Power Cord.
GBC StreamPunch Ultra/Ultra MP
02-03-2017
4-7
Adjustments/Repairs