Arp 3.8 Punch Alignment Stepper Motor And Pulley Replacement, And Alignment Stepper Bracket Replacement - GBC StreamPunch Ultra Service Manual

ARP 3.8 Punch Alignment Stepper Motor and Pulley Replacement,
and Alignment Stepper Bracket Replacement
PARTS LIST ON PL 4.7
Use this procedure to remove and install the Punch Alignment Stepper
Motor (M5) and Pulley, or the Alignment Stepper Mount Bracket.
Removal Procedure
WARNING
Do not perform Repair activities with the power on or electrical
power supplied to the machine. Some machine components contain
dangerous electrical voltages that can result in electrical shock and
possible serious injury.
1. Disconnect the Power Cord.
2. Do ARP 1.6 to remove the Rear Cover.
3. Do ARP 3.1 to remove the Punch Module. (This step is optional; it is
possible to replace the Alignment stepper bracket without removing
the punch module.
Punch Alignment Stepper Motor (M5)
Adjustments/Repairs
4. Remove the Phillips Screws (4) and remove the timing belt.
5. To replace the Alignment Stepper Mount Bracket
•
Remove the Screws (2) and the old Bracket.
•
Place the new Bracket in position and tighten the Screws (2).
6. Remove the Punch Alignment Stepper Motor and Pulley.
7. Place the timing Belt around the Pulley.
8. Do ADJ 1.4 to adjust the tension on the Belt.
9. Tighten the Phillips Screws (4).
10. Do ARP 3.1 to install the Punch Module if necessary
11. Close the Front Door.
12. Do ARP 1.6 to install the Rear Cover.
13. Connect the Power Cord.
.
GBC StreamPunch Ultra/Ultra MP
02-03-2017
4-92
Motor
Screws (4)
Belt