Ethernet Speed Setting A2; To Change The Network Speed; Go To Your Device - Xerox WorkCentre 7228 System Administrator Manual

Ethernet Speed Setting
The Device's Ethernet Interface has speed settings of Auto (10 BASE-T/100 BASE-TX), 100 BASE-TX
(Half or Full Duplex), and 10 BASE-T (Half or Full Duplex). By default the Ethernet Port Configuration will
be set to Auto.

To Change the Network Speed

Go to your Device

1. Press the Log In / Out button on the Control Panel.
2. Press the "1" key on the numeric keypad five consecutive times. (This is the factory default
"password.")
3. Press the rectangular Confirm button on the touch screen.
4. Press the System Settings button (the right-hand button of the two buttons displayed on the touch
screen). Note: If you press the left button by mistake, the Main menu will be displayed and you will
have to start over at step one above.
5. Press the System Settings button.
6. Press the Network Settings button.
7. Press the Protocol Settings button.
8. When the Protocol Settings menu displays, press the selection line labeled Ethernet Setting.
9. Press the Change Settings button.
10. On the Ethernet Setting screen note which one of the buttons is highlighted as the current setting for
Ethernet speed. The available settings are Auto (10 BASE-T/100 BASE-TX), 100 BASE-TX (Half or
Full Duplex), and 10 BASE-T (Half or Full Duplex). The default setting is Auto.
11. To change settings, press your setting of choice, then click the Save button.
12. To exit the Ethernet Setting screen, without making any changes, click the Cancel button.
13. To exit the Protocol Settings menu, returning to the Device's Main screen, press the rectangular
Close button. Next, press the rectangular Close button in the upper right corner of the Network
Settings screen. Press the rectangular Close button in the upper right corner of the System Settings
screen. Finally, press the rectangular Exit button in the upper right corner of the System Settings
screen.
14. Note that if you changed any settings in the Protocol Settings menu, the Device will automatically
reboot to register and enable your new settings.
A2
13