Configuration Examples; Example For Using Radius To Authenticate Users; Figure 1-1 Networking Diagram For Using Radius To Authenticate Users - Huawei Quidway S9300 Configuration Manual

Quidway S9300 Terabit Routing Switch
Configuration Guide - Security
When a running fault occurs on the RADIUS or HWTACACS server, run the debugging
commands in the user view to locate the fault.
Procedure
l
l
----End

1.9 Configuration Examples

This section provides several configuration examples of AAA and user management.

1.9.1 Example for Using RADIUS to Authenticate Users

1.9.2 Example for Using HWTACACS to Authenticate and Authorize Users
1.9.1 Example for Using RADIUS to Authenticate Users
Networking Requirements
As shown in
in to the S9300 to perform configurations. The user accesses the S9300 through Telnet and the
RADIUS server authenticates the access user.

Figure 1-1 Networking diagram for using RADIUS to authenticate users

User
Issue 01 (2009-07-28)
Run the debugging radius packet command to debug RADIUS packets.
Run the debugging hwtacacs { all | error | event | message | receive-packet | send-
packet } command to debug HWTACACS.
Figure 1-1, the ISP user on an IP/MPLS backbone network needs to remotely log
Primary server
10.1.1.1/24
IP/MPLS core
Metro
S9300-B
S9300-A
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
1 AAA and User Management Configuration
Standby server
10.1.1.2/24
1-33