Checking The Configuration; Configuration Examples; Example For Setting Primary And Secondary Ip Addresses - Huawei S9300 Configuration Manual

S9300&S9300E Terabit Routing Switch
Configuration Guide - IP Service
The interface is configured to borrow an IP address from the specified interface.
----End

1.4.4 Checking the Configuration

You can view the borrowed IP address of an interface.
Prerequisites
The configurations of IP address unnumbered are complete.
Procedure
l
l
----End

1.5 Configuration Examples

This section provides several examples of IP address configuration.

1.5.1 Example for Setting Primary and Secondary IP Addresses

This section provides a configuration example of setting primary and secondary IP addresses.
Networking Requirements
As shown in
hosts belong to two different network segments, that is 172.16.1.0/24 and 172.16.2.0/24. It is
required that the Switch can access the two network segments but the host in 172.16.1.0/24
cannot interconnect with the host in 172.16.2.0/24.
Figure 1-1 Networking diagram for setting IP addresses
Issue 01 (2012-03-15)
Run the display ip interface [ brief ] [ interface-type [ interface-number ] ] command to
check the IP configuration on the interface.
Run the display interface [ interface-type [ interface-number ] ] command to check
interface information.
Figure 1-1, GigabitEthernet 1/0/1 of the Switch is connected to a LAN, in which
172.16.1.0/24
172.16.2.0/24
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
1 IP Addresses Configuration
Switch
GE 1/0/1
VLANIF 100
172.16.1.1/24
172.16.2.1/24 sub
7