Enabling An Interface To Check The Source Ip Addresses Of Packets - Huawei S9300 Configuration Manual

S9300&S9300E Terabit Routing Switch
Configuration Guide - IP Service
l
l
l
Data Preparation
To optimize IP performance, you need the following data.
No.
1
2
3
6.3.2 Enabling an Interface to Check the Source IP Addresses of
Packets
Context
Do as follows on the S9300&S9300E.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
vlan vlan-id
A VLAN is created.
Step 3 Run:
quit
The system view is displayed.
Step 4 Run:
interface vlanif vlan-id
The VLANIF interface view is displayed.
Step 5 Run:
ip verify source-address
The interface is enabled to check the source IP addresses.
Issue 01 (2012-03-15)
Setting parameters of the link layer protocol for the interfaces to ensure that the status of
the link layer protocol on the interfaces is Up
Assigning IP addresses to interfaces
Configuring access control lists (ACLs)
Data
Number of the interface on which the Don't Fragment (DF) field of packets needs to
be deleted
Number of the interface on which ICMP redirection and ICMP host unreachable need
to be configured
Timeout interval of the TCP SYN-Wait timer, timeout interval of the TCP FIN-Wait
timer, receive or transmit buffer of the socket
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6 IP Performance Configuration
116