Subaru Legacy 2003 Service Manual page 2165

AUTOMATIC TRANSMISSION
B: ADJUSTMENT
1) Shift the select lever to "N" range.
2) Loosen the three inhibitor switch securing bolts.
3) Insert the ST as vertical as possible into the
holes in inhibitor switch lever and switch body.
ST 499267300 STOPPER PIN
4) Tighten the three inhibitor switch bolts.
Tightening torque:
3.5 N·m (0.35 kgf-m, 2.5 ft-lb)
5) Repeat the above checks. If the inhibitor switch
is determined to be "faulty", replace it.
INHIBITOR SWITCH
ST
AT-00032
AT-50
C: REMOVAL
1) Set the vehicle on a lift.
2) Move the select lever to "N" range.
3) Remove the air cleaner case. (2.0 L non-TURBO
and 2.5 L models)
<Ref. to IN(H4SO)-6, REMOVAL, Air Cleaner
Case.>
4) Remove air intake chamber. (3.0 L model)
<Ref. to IN(H6DO)-6, REMOVAL, Air Intake Cham-
ber.>
5) Remove intercooler. (2.0 L non-TURBO model)
<Ref. to IN(H4DOSTC)-13, REMOVAL, Intercool-
er.>
6) Disconnect the inhibitor switch connector.
(A)
(A) Inhibitor switch
7) Remove the inhibitor switch connector from stay.
8) Lift-up the vehicle.
9) Remove the front and center exhaust pipes.
(Non-TURBO model)
2.0 L and 2.5 L with OBD models
<Ref. to EX(H4SO)-5, REMOVAL, Front Exhaust
Pipe.>
2.0 L and 2.5 L without OBD models
<Ref. to EX(H4SOw/oOBD)-9, REMOVAL, Front
Exhaust Pipe.>
3.0 L model
<Ref. to EX(H6DO)-5, REMOVAL, Front Exhaust
Pipe.>
10) Remove center exhaust pipe. (TURBO model)
<Ref. to EX(H4DOSTC)-7, REMOVAL, Center Ex-
haust Pipe.>
AT-00033