Subaru Legacy 2003 Service Manual page 2250

Hide thumbs Also See for Legacy 2003:

Table of Contents

E: INSPECTION

1) Inspect the following items.

• Drive plate facing for wear and damage

• Snap ring for wear, return spring for setting and

breakage, and snap ring retainer for deformation

• Lip seal and D-ring for damage

• Piston and drum check ball for operation

• Adjust total end play. <Ref. to AT-117, ADJUST-

MENT, Oil Pump.>

2) Inspect clearance between the retaining plate

and snap ring. (High clutch) At this time, do not

press down retaining plate.

Standard value:

0.8 — 1.1 mm (0.031 — 0.043 in)

Allowable limit:

1.5 mm (0.059 in)

(A) Thickness gauge

3) If specified tolerance limits are exceeded, select

a suitable high clutch retaining plate.

High clutch retaining plate

4) Inspect clearance between retaining plate and

snap ring. (Reverse clutch) At this time, do not

press down retaining plate.

Standard value:

0.5 — 0.8 mm (0.020 — 0.031 in)

HIGH CLUTCH AND REVERSE CLUTCH

Thickness mm (in)

Allowable limit:

1.2 mm (0.047 in)

(A) Thickness gauge

5) If specified tolerance limits are exceeded, select

a suitable high clutch retaining plate.

Reverse clutch retaining plates

AUTOMATIC TRANSMISSION

Thickness mm (in)

Chapters

Table of Contents