Subaru Legacy 2003 Service Manual page 2271

AUTOMATIC TRANSMISSION
B: INSTALLATION
1) Install the low and reverse piston without tilting.
NOTE:
Be careful not to damage the lip seal.
2) Install return spring.
3) Install spring retainer.
4) Install the one-way clutch inner race. <Ref. to
AT-151, INSTALLATION, One-way Clutch.>
5) Install thrust needle bearing.
NOTE:
Place transmission case with the front facing up.
6) Installation of the low & reverse brake:
Install dish plate, driven plates, drive plates, and a
retaining plate, and secure with a snap ring.
LOW AND REVERSE BRAKE
AT-00300
AT-00301
AT-00302
AT-156
NOTE:
Pay attention to the orientation of the dish plate.
(A) Snap ring
7) Apply compressed air intermittently to check for
operation.
8) Check the clearance and select retaining plate.
<Ref. to AT-157, INSPECTION, Low and Reverse
Brake.>
9) Install 2-4 brake piston, retainer and return
spring to transmission case. <Ref. to AT-146, IN-
STALLATION, 2-4 Brake.>
10) Install planetary gear and low clutch assembly
to transmission case.
Install carefully while rotating the low clutch and
planetary gear assembly slowly paying special at-
tention not to damage the seal ring. <Ref. to AT-
137, INSTALLATION, Planetary Gear and Low
Clutch.>
11) Install the high clutch assembly. <Ref. to AT-
131, INSTALLATION, High Clutch and Reverse
Clutch.>
12) Install the oil pump housing assembly. <Ref. to
AT-113, INSTALLATION, Oil Pump.>
13) Install the control assembly and oil pan. <Ref.
to AT-61, INSTALLATION, Control Valve Body.>
14) Install the torque converter clutch case assem-
bly to the transmission case assembly. <Ref. to AT-
110, INSTALLATION, Torque Converter Clutch
Case.>
15) Install reduction driven gear.
<Ref. to AT-102, INSTALLATION, Reduction Driv-
en Gear.>
( A )
AT-00294
AT-00297