Subaru Legacy 2003 Service Manual page 2492

10.Transfer Drive Gear
A: REMOVAL
1) Remove the manual transmission assembly
from vehicle. <Ref. to MT-32, REMOVAL, Manual
Transmission Assembly.>
2) Remove back-up light switch and neutral posi-
tion switch. <Ref. to MT-42, REMOVAL, Switches
and Harness.>
3) Remove transfer case with extension case as-
sembly. <Ref. to MT-47, REMOVAL, Transfer
Case and Extension Case Assembly.>
4) Remove extension case assembly.
5) Remove transfer driven gear.
6) Remove transfer drive gear.
B: INSTALLATION
1) Install transfer drive gear.
Tightening torque:
26 N·m (2.7 kgf-m, 20 ft-lb)
2) Install transfer driven gear.
3) Install the extension case assembly.
4) Install transfer case and extension case assem-
bly. <Ref. to MT-47, INSTALLATION, Transfer
Case and Extension Case Assembly.>
5) Install back-up light switch and neutral position
switch. <Ref. to MT-43, INSTALLATION, Switches
and Harness.>
6) Install the manual transmission assembly from
vehicle. <Ref. to MT-35, INSTALLATION, Manual
Transmission Assembly.>
TRANSFER DRIVE GEAR
C: DISASSEMBLY
1) Remove snap ring.
2) Remove ball bearing.
MT-00133
D: ASSEMBLY
1) Set ST to inner race of bearing and install to
drive shaft.
ST 39817700
NOTE:
Do not apply pressure in excess of 10 kN (1 ton, 1.1
US ton, 1.0 Imp ton)
MT-00133
2) Install snap ring on transfer drive shaft.
3) Inspect clearance between snap ring and inner
race of ball bearing. <Ref. to MT-52, INSPECTION,
Transfer Drive Gear.>
MT-51
MANUAL TRANSMISSION AND DIFFERENTIAL
INSTALLER
MT-00135
MT-00136
ST
MT-00137