Subaru Legacy 2003 Service Manual page 2158

6) Tighten nuts and bolts which hold lower side of
transmission to engine.
Tightening torque:
50 N·m (5.1 kgf-m, 36.9 ft-lb)
Except 3.0 L model
3.0 L model
7) Lower the vehicle.
8) Connect engine and transmission.
(1) Remove ST from torque converter clutch
case.
NOTE:
Be careful not to drop the ST into the torque con-
verter clutch case when removing ST.
ST 498277200 STOPPER SET
(2) Install starter.
2.0 L non-TURBO and 2.5 L models
<Ref. to SC(H4SO)-6, INSTALLATION, Start-
er.>
3.0 L model
<Ref. to SC(H6DO)-6, INSTALLATION, Start-
er.>
2.0 L TURBO model
<Ref. to SC(H4DOSTC)-6, INSTALLATION,
Starter.>
(3) Tighten bolt which holds right upper side of
transmission to engine.
Tightening torque:
50 N·m (5.1 kgf-m, 36.9 ft-lb)
AUTOMATIC TRANSMISSION ASSEMBLY
AT-00108
AT-00689
Except 3.0 L model
3.0 L model
9) Install torque converter clutch to drive plate.
(1) Tighten bolts which hold torque converter
clutch to drive plate.
(2) Tighten other bolts while rotating the engine
by using ST.
NOTE:
Be careful not to drop bolts into torque converter
clutch housing.
• Except 2.0 L model
ST 499977100
• 2.0 L model
ST 499977400
Tightening torque:
25 N·m (2.5 kgf-m, 18.1 ft-lb)
(3) Clog plug onto service hole.
AT-43
AUTOMATIC TRANSMISSION
AT-00106
AT-00681
CRANKSHAFT PULLEY
WRENCH
CRANKSHAFT PULLEY
WRENCH
AT-00102