Subaru Legacy 2003 Service Manual page 1835

STARTING/CHARGING SYSTEMS
3. Generator
A: REMOVAL
1) Disconnect the ground cable from battery.
2) Disconnect the connector and terminal from
generator.
3) Remove the V-belt cover.
4) Remove the front side V-belt.
<Ref. to ME(H4DOSTC)-42, REMOVAL, V-belt.>
5) Remove the bolts which install generator onto
bracket.
B: INSTALLATION
Install in the reverse order of removal.
CAUTION:
Check and adjust the V-belt tension. <Ref. to
ME(H4DOSTC)-43, INSPECTION, V-belt.>
GENERATOR
C: DISASSEMBLY
1) Remove the four through-bolts.
2) Heat the portion (A) of rear cover to 50°C
(122°F) with heater drier.
FU-00009
3) Then insert the tip of a flat tip screwdriver into the
gap between stator core and front cover. Pry them
apart to disassemble.
4) Hold the rotor with a vise and remove pulley nut.
SC-00032
SC-00032
SC(H4DOSTC)-14
(A)
(A) Screwdriver
(A)
SC-00079
(A)
SC-00080
SC-00035