Subaru Legacy 2003 Service Manual page 2274

B: INSTALLATION
1) Install detention spring to transmission case.
Tightening torque:
6 N·m (0.6 kgf-m, 4.3 ft-lb)
2) Insert range select lever, and tighten bolt.
Tightening torque:
6 N·m (0.6 kgf-m, 4.3 ft-lb)
3) Insert manual plate and parking rod.
( A )
( B )
(A) Bolt
(B) Range select lever
(C) Manual plate
(D) Parking rod
TRANSMISSION CONTROL DEVICE
AT-00307
AT-00308
( C )
( D )
AT-00306
AT-159
4) Insert spring pin to manual plate.
5) Install control valve assembly and oil pan. <Ref.
to AT-61, INSTALLATION, Control Valve Body.>
6) Turn over the transmission case to its original
position.
7) Install pitching stopper bracket.
Tightening torque:
41 N·m (4.2 kgf-m, 30.4 ft-lb)
8) Install inhibitor switch and adjust the inhibitor
switch. <Ref. to AT-49, Inhibitor Switch.>
9) Insert inhibitor switch and transmission connec-
tor into stay.
( B )
(A) Transmission harness
(B) Inhibitor switch harness
10) Install air breather hose. <Ref. to AT-83, IN-
STALLATION, Air Breather Hose.>
11) Insert the input shaft while turning lightly by
hand. At this time, not to damage the bushing.
Normal protrusion A:
50 — 55 mm (1.97 — 2.17 in)
A
AUTOMATIC TRANSMISSION
AT-00305
( A )
AT-00174
AT-00291