Subaru Legacy 2003 Service Manual page 2502

10) Remove drive pinion shaft assembly from left
side transmission case.
NOTE:
Use a hammer handle, etc. to remove if too tight.
( B )
(A) Main shaft assembly
(B) Drive pinion shaft assembly
11) Removing high-low shifter fork
Raise main shaft assembly slightly, and remove
high-low shifter fork together with high-low shifter
shaft and washer.
NOTE:
Be careful not to drop the two high-low shifter piec-
es.
( B ) ( A )
(A) High-low shifter fork
(B) Input shaft ASSY
TRANSMISSION CASE
12) Remove main shaft assembly and input shaft
assembly.
NOTE:
Be careful not to drop input shaft and main shaft as
they are separable.
( A )
MT-00161
13) Remove differential assembly.
NOTE:
• Be careful not to confuse right and left roller
bearing outer races.
• Be careful not to damage retainer oil seal.
MT-00169
B: INSTALLATION
1. SINGLE-RANGE
1) Wipe off grease, oil and dust on the mating sur-
faces of transmission cases with white gasoline.
2) Install the front differential assembly.
3) Install the main shaft assembly.
Install needle bearing knock pin hole into transmis-
sion case knock pin.
4) Install the drive pinion shaft assembly.
Install roller bearing knock pin hole into transmis-
sion case knock pin.
5) Apply liquid gasket, and then put case right side
and left side together.
Liquid gasket:
MT-61
MANUAL TRANSMISSION AND DIFFERENTIAL
(B)
(A) Main shaft ASSY
(B) Input shaft ASSY
THREE BOND 1215 (Part No. 004403007) or
equivalent
(A)
MT-00170
MT-00162