Subaru Legacy 2003 Service Manual page 2230

19) Install the transmission assembly to the vehi-
cle. <Ref. to AT-42, INSTALLATION, Automatic
Transmission Assembly.>
C: DISASSEMBLY
1) Remove four seal rings.
( A )
(A) Seal rings
2) Lightly tap the end of the stator shaft to remove
the cover.
( A )
(A) Oil pump cover
(B) Oil pump housing
3) Remove the inner and outer rotor.
( A )
(A) Inner rotor
(B) Outer rotor
( A )
AT-00189
( B )
AT-00190
( B )
AT-00191
OIL PUMP
D: ASSEMBLY
1) Install oil pump rotor assembly to oil pump hous-
ing.
(A) Inner rotor
(B) Outer rotor
2) Align both pivots with the pivot holes of the cov-
er, and install the oil pump cover being careful not
to apply undue force to the pivots.
Tightening torque:
25 N·m (2.5 kgf-m, 18.1 ft-lb)
( A )
(A) Oil pump cover
(B) Oil pump housing
3) After assembling, turn the oil pump shaft to
check for smooth rotation of the rotor.
AT-115
AUTOMATIC TRANSMISSION
( A )
( B )
( B )
AT-00191
AT-00190