Subaru Legacy 2003 Service Manual page 1865

ENGINE (DIAGNOSTICS)
9. Subaru Select Monitor
A: OPERATION
1. HOW TO USE SUBARU SELECT MONI-
TOR
1) Prepare the Subaru Select Monitor kit. <Ref. to
EN(H4DOSTC)-8, PREPARATION TOOL, Gener-
al Description.>
2) Connect the diagnosis cable to Subaru Select
Monitor.
3) Insert the cartridge into Subaru Select Monitor.
<Ref. to EN(H4DOSTC)-8, PREPARATION TOOL,
General Description.>
4) Connect the Subaru Select Monitor to data link
connector.
(1) Data link connector located in the lower por-
tion of the instrument panel (on the driver's
side).
SUBARU SELECT MONITOR
EN-00038
ST
EN-00039
EN-00999
EN(H4DOSTC)-26
(2) Connect the diagnosis cable to data link
connector.
CAUTION:
Do not connect scan tools except for the
Subaru Select Monitor and OBD-II general scan
tool.
5) Turn the ignition switch to ON (engine OFF) and
Subaru Select Monitor switch to ON.
(A) Power switch
6) Using the Subaru Select Monitor, call up the di-
agnostic trouble code(s) and various data, then
record them.
2. READ DIAGNOSTIC TROUBLE CODE
(DTC) FOR ENGINE. (NORMAL MODE)
Refer to Read Diagnostic Trouble Code for infor-
mation about how to indicate DTC. <Ref. to
EN(H4DOSTC)-32,
Code.>
3. READ DIAGNOSTIC TROUBLE CODE
(DTC) FOR ENGINE. (OBD MODE)
Refer to Read Diagnostic Trouble Code for infor-
mation about how to indicate DTC. <Ref. to
EN(H4DOSTC)-32,
Code.>
( A )
EN-00040
Read Diagnostic Trouble
Read Diagnostic Trouble