Subaru Legacy 2003 Service Manual page 2508

MAIN SHAFT ASSEMBLY FOR SINGLE-RANGE
5) Using ST1, ST2 and a press, remove ball bear-
ing, synchro cone and baulk ring (Rev).
NOTE:
• Replace sleeve and hub with new ones. Do not
attempt to disassemble because they must engage
at a specified point. If they should be disassem-
bled, mark engagement point on splines before-
hand.
• Do not reuse ball bearing.
ST1 499757002 INSTALLER
ST2 498077400 SYNCHRO CONE REMOV-
ER
ST1
( A )
(A) Ball bearing
(B) Synchro cone
(C) Baulk ring
ST2
( B )
( C )
MT-00189
MT-67
MANUAL TRANSMISSION AND DIFFERENTIAL
6) Using ST1 and ST2, remove the rest of parts.
NOTE:
Replace sleeve and hub with new ones. Do not at-
tempt to disassemble because they must engage
at a specified point. If they should be disassem-
bled, marking engagement point on splines before-
hand.
ST1 899864100 REMOVER
ST2 899714110 REMOVER
ST2
(A) Press
( A )
ST1
MT-00190