Subaru Legacy 2003 Service Manual page 2196

3) Connect ATF cooler hose to pipe transmission
side.
NOTE:
• Install so that the hose is not folded over, exces-
sively bent, or twisted.
• Be careful to insert the hose to the specified po-
sition.
4) Connect ATF cooler hose to pipe of radiator
side.
NOTE:
• Install so that the hose is not folded over, exces-
sively bent, or twisted.
• Be careful to insert the hose to the specified po-
sition.
5) Install the under cover.
6) Install battery and washer tank.
7) Fill ATF. <Ref. to AT-30, Automatic Transmis-
sion Fluid.>
NOTE:
Make sure there are no ATF leaks in joints between
the transmission, radiator, pipes, and hoses.
2. 3.0 L MODEL
1) Install the oil cooler outlet and inlet pipes.
NOTE:
Be sure to use a new aluminum washer.
ATF COOLER PIPE AND HOSE
AT-00683
AT-00703
AT-81
Tightening torque:
T1: 44 N·m (4.5 kgf-m, 32.5 ft-lb)
T2: 25 N·m (2.5 kgf-m, 18.1 ft-lb)
T1
2) Install ATF cooler pipe to frame.
3) Connect ATF cooler hose to transmission.
NOTE:
• Install so that the hose is not folded over, exces-
sively bent, or twisted.
• Be careful to insert the hose to the specified po-
sition.
AUTOMATIC TRANSMISSION
T1
T2
AT-00805
AT-00707
AT-00683