Subaru Legacy 2003 Service Manual page 2180

8) Install lower separate plate to lower valve body.
(A) Lower separator plate
(B) Lower valve body
9) Temporarily assemble valve body.
NOTE:
Be careful not to drop the middle valve body and
upper body interior steel ball, or the lower body fil-
ter.
10) Tighten bolts.
NOTE:
Install the bolts (D) from upper valve body side.
Tightening torque:
8 N·m (0.8 kgf-m, 5.8 ft-lb)
D
B B
A
A
A
Bolt length mm (in)
(A) 40 (1.57)
(B) 62 (2.44)
(C) 73 (2.87)
(D) 79 (3.11)
CONTROL VALVE BODY
( A )
( B )
AT-00076
AT-00077
C
B
B
B
B
D
AT-00904
11) Install the sensor, solenoids and duty solenoids
to specified positions.
(A) Lock-up duty solenoid (Blue)
(B) Low clutch timing solenoid (Gray)
(C) Line pressure duty solenoid (Red)
(D) Shift solenoid 1 (Yellow)
(E) Shift solenoid 2 (Green)
(F) 2-4 brake timing solenoid (Black)
(G) 2-4 brake duty solenoid (Red)
(H) SPORT shift solenoid (Beige) (if equipped)
12) Tighten the bolts and nuts.
Tightening torque:
8 N·m (0.8 kgf-m, 5.8 ft-lb)
Bolt length mm (in)
(A) 12 (0.47)
(B) 40 (1.57)
(C) 45 (1.77)
(D) 62 (2.44)
(E) 73 (2.87)
AT-65
AUTOMATIC TRANSMISSION
( C )
( A )
( B )
( G )
E
E
E
A
D
C
C
B
( D )
( E )
( H )
( F )
AT-00903
D
D
D
B
AT-00905