Subaru Legacy 2003 Service Manual page 2476

27) Remove spring pins and separate front drive
shafts from each side of the transmission.
NOTE:
Discard removing spring pin. Replace with a new
one.
28) Remove nuts which hold lower side of trans-
mission to engine.
29) Place transmission jack under transmission.
CAUTION:
• Always support transmission case with a
transmission jack.
• Fix transmission with a band etc.
MANUAL TRANSMISSION ASSEMBLY
MT-00357
MT-00077
MT-00078
MANUAL TRANSMISSION AND DIFFERENTIAL
30) Remove transmission rear crossmember from
vehicle.
31) Move transmission jack toward rear until main
shaft is withdrawn from clutch cover.
32) Separate transmission assembly and rear
cushion rubber.
B: INSTALLATION
1) Install clutch release bearing and lever to trans-
mission. (TURBO model)
<Ref. to CL-22, INSTALLATION, Release Bearing
and Lever.>
2) Install rear cushion rubber to transmission as-
sembly.
Tightening torque:
35 N·m (3.6 kgf-m, 26 ft-lb)
3) Install transmission onto engine.
(1) Gradually raise transmission with transmis-
sion jack.
(2) Engage them at splines.
NOTE:
Be careful not to strike main shaft against clutch
cover.
4) Install transmission rear crossmember.
Tightening torque:
T1: 70 N·m (7.1 kgf-m, 51 ft-lb)
T2: 140 N·m (14.3 kgf-m, 103 ft-lb)
T1
T2
5) Take off transmission jack.
MT-35
MT-00079
T1
T2
MT-00081