Subaru Legacy 2003 Service Manual page 2537

MANUAL TRANSMISSION AND DIFFERENTIAL
C: DISASSEMBLY
1. DIFFERENTIAL CASE ASSEMBLY
1) Remove right and left snap rings from differen-
tial, and then remove two axle drive shafts.
NOTE:
During reassembly, reinstall each axle drive shaft
in the same place from which it was removed.
2) Loosen twelve bolts and remove hypoid driven
gear.
(A)
(A) Hypoid driven gear
3) Drive out straight pin from differential assembly
toward hypoid driven gear.
ST 899904100 REMOVER
FRONT DIFFERENTIAL ASSEMBLY
MT-00275
ST
MT-00276
MT-96
4) Pull out pinion shaft, and remove differential
bevel pinion and gear and washer.
( A )
(A) Pinion shaft
(B) Bevel pinion
(C) Bevel gear
(D) Washer
5) Remove roller bearing using ST.
ST 399527700 PULLER SET
ST
2. SIDE RETAINER
1) Remove O-ring.
( C )
( D )
( B )
( C )
( B ) ( D )
MT-00277
MT-00278
MT-00279