Subaru Legacy 2003 Service Manual page 1683

MECHANICAL
(3) Install the power steering pipe bracket on
right side intake manifold.
(4) Connect the power steering switch connec-
tor.
(5) Install the front side V-belt, and adjust it.
<Ref. to ME(H4DOSTC)-42, INSTALLATION,
V-belt.>
13) Lift-up the vehicle.
14) Tighten the nuts which hold lower side of trans-
mission to engine.
Tightening torque:
50 N·m (5.1 kgf-m, 36.9 ft-lb)
ENGINE ASSEMBLY
15) Tighten the nuts which install front cushion rub-
ber onto crossmember.
Tightening torque:
NOTE:
Make sure the front cushion rubber mounting bolts
(A) and locator (B) are securely installed.
ME-00631
16) Install the ATF cooler pipe to frame. (AT vehi-
cles)
17) Install the center exhaust pipe.
<Ref. to EX(H4DOSTC)-8, INSTALLATION, Center
Exhaust Pipe.>
18) Lower the vehicle.
ME-00035
19) Connect the following hoses:
(1) Fuel delivery hose, return hose and evapo-
ration hose
(2) Heater inlet and outlet hoses
(3) Brake booster vacuum hose
20) Connect the following connectors and termi-
nals:
(1) Engine ground terminal
(2) Engine harness connectors
(3) Generator connector and terminal
(4) A/C compressor connectors
21) Connect the following cables:
(1) Accelerator cable
(2) Clutch release spring
22) After connecting each cable, adjust them.
23) Install the air intake system.
(1) Install
IN(H4DOSTC)-14, INSTALLATION, Intercool-
er.>
(2) Install the air cleaner element and air clean-
ME-00040
er upper cover.
(3) Install the engine harness connector brack-
et.
(4) Install the filler hose to air cleaner case.
ME(H4DOSTC)-38
83 N·m (8.5 kgf-m, 61 ft-lb)
( B ) ( A )
the intercooler.
( A ) ( B )
ME-00056
<Ref. to