Subaru Legacy 2003 Service Manual page 2509

MAIN SHAFT ASSEMBLY FOR SINGLE-RANGE
MANUAL TRANSMISSION AND DIFFERENTIAL
D: ASSEMBLY
1. 2.0 L SOHC
1) Assemble when each sleeve and hub assembly
are disassembled.
NOTE:
Position open ends of spring 120° apart.
( A )
( B )
( C )
( D )
(A) 3rd-4th hub ASSY
(B) 3rd gear side
(C) 5th-Rev hub ASSY
(D) 5th gear side
2) Install 3rd drive gear, baulk ring, sleeve and hub
assembly for 3rd needle bearing on transmission
main shaft.
NOTE:
Align groove in baulk ring with shifting insert.
3) Install 4th needle bearing race onto transmission
main shaft using ST1, ST2 and a press.
NOTE:
Do not apply pressure in excess of 10 kN (1 ton, 1.1
US ton, 1.0 Imp ton).
ST1 899714110
ST2 499877000
4) Install baulk ring, needle bearing, 4th drive gear
and 4th gear thrust washer to transmission main
shaft.
NOTE:
Align baulk ring and gear & hub assembly with key
groove.
MT-00191
MT-68
REMOVER
RACE 4-5 INSTALLER
ST2
( A )
ST1
(A) 4th needle bearing race
( B )
(A) Groove
(B) 4th gear side
MT-00192
( A )
MT-00193