Subaru Legacy 2003 Service Manual page 2247

AUTOMATIC TRANSMISSION
12) Insert the input shaft while turning lightly by
hand. At this time, not to damage the bushing.
Normal protrusion A:
50 — 55 mm (1.97 — 2.17 in)
A
13) Install the torque converter clutch assembly.
<Ref. to AT-85, INSTALLATION, Torque Converter
Clutch Assembly.>
14) Install the transmission assembly to the vehi-
cle. <Ref. to AT-42, INSTALLATION, Automatic
Transmission Assembly.>
HIGH CLUTCH AND REVERSE CLUTCH
AT-00291
C: DISASSEMBLY
1) Remove the snap ring, and take out the retaining
plate, drive plates, driven plates.
( A )
(A) Snap ring
2) Remove snap ring, and take out the retaining
plate, drive plates and driven plates.
(A) Snap ring
3) Using ST1 and ST2, remove snap ring.
ST1 398673600
ST2 498627100
( A )
(A) Snap ring
AT-132
( A )
COMPRESSOR
SEAT
AT-00236
AT-00237
ST1
ST2
AT-00238