AUTOMATIC TRANSMISSION
26.Transfer Clutch
A: REMOVAL
1) Remove the transmission assembly from vehi-
cle. <Ref. to AT-39, REMOVAL, Automatic Trans-
mission Assembly.>
2) Remove rear vehicle speed sensor.
( B )
(A) Rear vehicle speed sensor
(B) Front vehicle speed sensor
3) Separate transmission case and extension case
sections.
4) Take out the transfer clutch by lightly tapping the
end of the rear drive shaft.
( B )
(A) Transfer clutch
(B) Extension case
TRANSFER CLUTCH
( A )
AT-00116
AT-00118
( A )
AT-00119
AT-90
B: INSTALLATION
1) Select the thrust needle bearing.
2) Install the transfer clutch assembly to the case.
( A )
( B )
(A) Transfer clutch
(B) Extension case
3) Tighten bolts to secure the case.
Tightening torque:
25 N·m (2.5 kgf-m, 18.1 ft-lb)
4) Install the transmission assembly to vehicle.
<Ref. to AT-42, INSTALLATION, Automatic Trans-
mission Assembly.>
AT-00125
AT-00118