Subaru Legacy 2003 Service Manual page 2217

AUTOMATIC TRANSMISSION
B: INSTALLATION
1. MPT MODEL
1) Set the select lever to "P" range.
2) Using a plastic hammer, install reduction driven
gear assembly and new washer, and tighten new
drive pinion lock nut.
Tightening torque:
100 N·m (10.2 kgf-m, 73.8 ft-lb)
(A) Reduction driven gear
(B) Reduction drive gear
3) After tightening, stake the lock nut securely.
4) Combine the transmission case with the exten-
sion case, and install rear vehicle speed sensor.
<Ref. to AT-86, INSTALLATION, Extension Case.>
5) Install the transmission assembly to vehicle.
<Ref. to AT-42, INSTALLATION, Automatic Trans-
mission Assembly.>
2. VTD MODEL
1) Set the select lever to "P" range.
2) Using a plastic hammer, install reduction driven
gear assembly.
3) Using a plastic hammer, install the center differ-
ential assembly.
4) Install a new self-lock nut and a washer.
Tightening torque:
100 N·m (10.2 kgf-m, 73.8 ft-lb)
(A) Reduction driven gear
(B) Reduction drive gear
REDUCTION DRIVEN GEAR
( B )
( A )
AT-00153
AT-00155
AT-102
5) After tightening, stake the lock nut securely.
6) Insert the rear drive shaft assembly. <Ref. to AT-
99, INSTALLATION, Rear Drive Shaft.>
7) Combine the transmission case with the exten-
sion case, and install rear vehicle speed sensor.
<Ref. to AT-86, INSTALLATION, Extension Case.>
8) Install the transmission assembly to vehicle.
<Ref. to AT-42, INSTALLATION, Automatic Trans-
mission Assembly.>