Subaru Legacy 2003 Service Manual page 2521

MANUAL TRANSMISSION AND DIFFERENTIAL
3) Install 4th needle bearing race onto transmission
main shaft using ST1, ST2 and a press.
ST1 899714110 REMOVER
ST2 499877000 RACE 4-5 INSTALLER
ST2
( A )
ST1
(A) 4th needle bearing race
4) Install baulk ring, needle bearing, 4th drive gear
and 4th gear thrust washer to transmission main
shaft.
NOTE:
Face thrust washer in the correct direction.
( B )
(A) Groove
(B) 4th gear side
5) Drive ball bearing onto the rear section of trans-
mission main shaft using ST1, ST2 and a press.
ST1 899714110 REMOVER
ST2 499877000 RACE 4-5 INSTALLER
MAIN SHAFT ASSEMBLY FOR DUAL-RANGE
MT-00192
( A )
MT-00193
ST2
ST1
MT-00194
6) Using ST1 and ST2, install the 5th gear thrust
washer and 5th needle bearing race onto the rear
section of transmission main shaft.
NOTE:
Face thrust washer in the correct direction.
ST1 899714110
ST2 499877000
(A) Face this surface to 5th gear side.
7) Install bearing onto synchro cone.
8) Install new baulk ring and synchro cone onto
5th-Rev sleeve and hub assembly using ST and a
press.
NOTE:
After press fitting, make sure synchro cone rotates
freely.
ST 499757002
( A ) ( B )
(A) Baulk ring
(B) Synchro cone
(C) Ball bearing
MT-80
REMOVER
RACE 4-5 INSTALLER
( A )
MT-00195
INSTALLER
ST
( C )
MT-00196