Subaru Legacy 2003 Service Manual page 2573

CLUTCH SYSTEM
3. Flywheel
A: REMOVAL
1. EUROPE AND AUSTRALIA NON-TURBO
MODELS
1) Remove transmission assembly. <Ref. to MT-
32, REMOVAL, Manual Transmission Assembly.>
2) Remove clutch cover and clutch disc. <Ref. to
CL-15, REMOVAL, Clutch Disc and Cover.>
3) Remove flywheel using ST1 and ST2.
ST1 498497100 CRANKSHAFT STOPPER
ST2 499057000 TORX PLUS
( A )
ST1
(A) Flywheel
2. EXCEPT EUROPE AND AUSTRALIA
NON-TURBO MODELS AND TURBO MOD-
EL
1) Remove transmission assembly. <Ref. to MT-
32, REMOVAL, Manual Transmission Assembly.>
2) Remove clutch cover and clutch disc. <Ref. to
CL-15, REMOVAL, Clutch Disc and Cover.>
3) Using ST, remove flywheel.
ST 498497100 CRANKSHAFT STOPPER
( A )
(A) Flywheel
B: INSTALLATION
1. EUROPE AND AUSTRALIA NON-TURBO
MODELS
1) Install flywheel and ST.
FLYWHEEL
ST2
CL-00121
ST
CL-00019
CL-20
ST 498497100 CRANKSHAFT STOPPER
2) Tighten the flywheel attaching bolts to the spec-
ified torque.
ST 499057000 TORX PLUS
NOTE:
Tighten flywheel installing bolts gradually. Each
bolt should be tightened to the specified torque in a
crisscross fashion.
Tightening torque:
72 N·m (7.3 kgf-m, 52.8 ft-lb)
( 5 )
( 3 )
( 8 )
3) Install clutch disc and cover. <Ref. to CL-15, EU-
ROPE AND AUSTRALIA NON-TURBO MODELS,
INSTALLATION, Clutch Disc and Cover.>
4) Install transmission assembly. <Ref. to MT-35,
INSTALLATION, Manual Transmission Assem-
bly.>
ST
CL-00122
( 1 )
( 7 )
( 4 )
( 6 )
( 2 )
CL-00123