Subaru Legacy 2003 Service Manual page 2498

2) Remove reverse check plate, reverse check
spring, reverse check cam, return spring (5th-Rev),
reverse accent shaft, return spring cap and return
spring (1st-2nd).
( A )
( B )
( D )
( F )
(A) Reverse check plate
(B) Reverse check spring
(C) Return spring (5th-Rev)
(D) Reverse check cam
(E) Reverse accent shaft
(F) Return spring cap
(G) Return spring (1st-2nd)
3) Remove O-ring.
NOTE:
• Reverse check sleeve assembly uses an O-ring
which should not be scratched.
• Be careful not to break adjustment shim placed
between reverse check sleeve assembly and case.
REVERSE CHECK SLEEVE
( C )
( E )
( G )
MT-00154
MANUAL TRANSMISSION AND DIFFERENTIAL
D: ASSEMBLY
1) Install return spring (1st-2nd), return spring cap,
reverse accent shaft, check cam, return spring and
check spring onto reverse check sleeve.
NOTE:
Be sure the bent section of reverse check spring is
positioned in the groove in check cam.
( F )
(A) Reverse check sleeve
(B) Return spring (1st-2nd)
(C) Return spring cap
(D) Reverse accent shaft
(E) Return spring (5th-Rev)
(F) Reverse check cam
(G) Reverse check spring
2) Hook the bent section of reverse check spring
over reverse check plate.
3) Rotate cam so that the protrusion of reverse
check cam is at the opening in plate.
4) With cam held in that position, install plate onto
reverse check sleeve and hold with snap ring.
5) Position new O-ring in groove in sleeve.
MT-57
( G )
( E )
( C )
( D )
( B )
( A )
MT-00361