Subaru Legacy 2003 Service Manual page 2592

(2) Ensure that the clutch pedal contacts clutch
pedal bracket stopper, when fully depressing
the clutch pedal.
(A)
(B)
(C)
(D)
(A) Clevis hole
(B) Push rod lock nut
(C) Lengthening direction
(D) Shortening direction
(E) Push rod
(F) U shaped bracket
5) Turn the push rod clockwise to shorten until
clearance is made at stopper bolt or clutch switch.
(A)
(A) Stopper bolt
6) Turn the push rod counter clockwise to lengthen
until clutch pedal contacts to stopper bolt or clutch
switch.
7) Turn the push rod further 270× counterclockwise
to lengthen (arrow direction as shown in the figure).
(A)
(A) Clutch pedal
(B) Brake pedal
CLUTCH PEDAL
(F)
(E)
CL-00080
CL-00134
(B)
CL-00085
CL-39
8) Move the clevis pin in lateral direction to ensure
it moves smoothly.
9) Tighten the push rod lock nut.
Tightening torque (Clutch stopper nut):
10 N·m (1.0 kgf-m, 7.2 ft-lb)
10) Measure the full stroke amount of clutch pedal
again.
Specified clutch pedal full stroke: A
130 — 135 mm (5.12 — 5.31 in)
11) Install the clutch switch. <Ref. to CL-40, IN-
STALLATION, Clutch Switch.>
CLUTCH SYSTEM