Subaru Legacy 2003 Service Manual page 2097

CONTROL SYSTEMS
2. Select Lever
A: REMOVAL
1) Set the vehicle on a lift.
2) Disconnect negative cable from battery.
3) Move the select lever to the "N" position.
4) Lift-up the vehicle.
5) Remove rear exhaust pipe and muffler.
2.0 L and 2.5 L with OBD models
<Ref. to EX(H4SO)-9, REMOVAL, Rear Exhaust
Pipe.> and <Ref. to EX(H4SO)-10, REMOVAL,
Muffler.>
2.0 L and 2.5 L without OBD models
<Ref. to EX(H4SOw/oOBD)-13, REMOVAL, Rear
Exhaust Pipe.> and <Ref. to EX(H4SOw/oOBD)-
14, REMOVAL, Muffler.>
3.0 L model
<Ref. to EX(H6DO)-8, REMOVAL, Rear Exhaust
Pipe.> and <Ref. to EX(H6DO)-9, REMOVAL, Muf-
fler.>
Turbo model
<Ref. to EX(H4DOSTC)-12, REMOVAL, Rear Ex-
haust Pipe.> and <Ref. to EX(H4DOSTC)-13, RE-
MOVAL, Muffler.>
6) Remove heat shield cover. (If equipped)
7) Disconnect cable from select lever and then re-
move cable bracket.
( B )
(A) Adjusting nuts
(B) Cable bracket
8) Lower the vehicle.
9) Remove console box. <Ref. to EI-34, REMOV-
AL, Console Box.>
SELECT LEVER
AT-00682
( A )
CS-00017
CS-8
10) Disconnect the connectors, then remove the
four bolts to take out the select lever assembly from
the body.
B: INSTALLATION
1) Mount the select lever onto the vehicle body.
2) Tighten the four bolts to install the select lever to
the vehicle body, then connect connector.
Tightening torque:
13 N·m (1.3 kgf-m, 9.4 ft-lb)
3) Install console box. <Ref. to EI-34, INSTALLA-
TION, Console Box.>
4) Set location of select lever at "N" position.
5) Lift-up the vehicle.
6) Set location of range select lever to "N" position.
7) Insert the thread portion of the other inner cable
and into the connector hole of the select lever, and
fix the other outer cable end to the bracket.
Tightening torque:
18 N·m (1.8 kgf-m, 13.0 ft-lb)
8) Adjust the select cable position. <Ref. to CS-14,
ADJUSTMENT, Select Cable.>
9) After completion of fitting, make sure that the se-
lect lever operates smoothly all across the operat-
ing range.
10) Install heat shield cover. (If equipped)
CS-00018
CS-00019